The Control Panel; Changing A Programme - Nordmende DW67SL User Manua

7. THE CONTROL PANEL

Rotate the Programme Selection Knob (4)
to select the suitable programme for your
dishes. When in the 'Off' position, your
machine will not have power.
Press Start/Pause button (3) to start the
selected program. The Start/ Pause light will
switch off and the Wash light will illuminate.
If the door is opened while a program is in
operation, the Start/Pause light will flash
and the Wash light will remain illuminated.
The program status can be monitored via
the Wash, Rinse, Dry and End lights (7) on
the control panel. The machine will remain
silent for about 40-50 minutes - while drying
is in operation, the Drying light will be
illuminated.
The Remaining Time Indicator (1) shows
the duration of the selected programme
and the time remaining of the operating
programme.
NOTE: Pressing the Half Load button
(2) will reduce the duration of the selected
programme and will therefore reduce the
energy and water consumption.
NOTE: If an extra feature has been
used, such as Delay or Half Load (1, 2), on
the latest wash program, the feature will
remain active on the next washing program.
To cancel this feature on the next newly
selected wash program, turn the Program
Selection Knob to the 'Off' position, then
turn the knob so the machine is on again.
You may select an extra feature with the
newly selected program.
NOTE: Child Lock is activated/
deactivated by pressing both the "+" and
"-" buttons simultaneously for 3 seconds.
When Child Lock is activated, "CL" will
show on the Remaining Time Indicator (1)
for 2 seconds. When it is deactivated, "CL"
will flash twice on the Remaining Time
Indicator (1).
NOTE: If there is not enough rinse aid
in the machine, the Rinse Aid Lack Warning
Indicator (6) will illuminate to indicate the
rinse aid chamber needs filling.
NOTE: Press the "+" and "-" buttons on
the Remaining Time Indicator (1) to delay
the program start time, before the program
has started, for 1 hour up to 19 hours.
To change the delay time, press the Start/
Pause button (3), and use the "+" and "-"
buttons to select a new delay time. Then,
press the Start/Pause button (3) to activate
the new delay time. Change the delay time
to '0' using the "+" and "-" buttons if you
wish to cancel the delay.
NOTE: If the Programme Selection
Knob (4) is turned to the 'Off' position after
a delay time has been selected and the
programme has started, the remaining
delay time will be stored. When the knob is
turned to a new programme, the remaining
delay time will resume.

7.1. Changing a programme

Follow the steps listed below to change a
programme while it is in operation.
Press the Start/Pause
After the program stops, select
your desired program using the
Program Selection Knob.
EN - 17
button.