Emerson QUIET KOOL EAPC8RD1 Owner's Manual page 17

Installation in a sliding sash window
1. Cut the foam seals A (adhesive type) to the proper length and attach them to
the window and sill. (Fig.14)
2. Open the window sash and place the window slider kit on the window sill
(Fig.15). Attach the window slider kit to the window sill. Adjust the length of the
window slider kit according to the window's width. Attach two screws on the
window slider kit. See Fig.15.
Cut the adjustable window slider kit if the window's width is less than 26.6
inches (Fig.10).
3.Close the window sash securely against the window slider kit. (Fig.16)
4.Drive two ½" screws to secure the window slider kit to the window sash.
(Fig.16)
5. Drive two ¾" screws to secure the window slider kit to the window sill. (Fig.16)
6. Cut the foam seal B to an appropriate length and seal the open gap between
the sliding sash and outer window sash, as shown in (Fig.17).
6. To secure sliding sash in place, attach right angle sash lock with ½" (12.7 mm)
screw as shown (Fig.18).
INSTALLATION INSTRUCTIONS
Continuous Drainage
Under the DRY mode, you will need a garden hose (sold separately) to drain the condensate from the unit.
Follow the steps below:
• Unscrew the cap on continuous drain outlet (Fig.20).
• Connect one end of the garden hose (sold separately) to the drain outlet, then lead the other end into
a drain that is lower than the unit (Fig.21).
Figure 20 Figure 21
NOTE
• Condensate may flow out after removing the drain cap, if the unit is running in Cool or ECO mode. When you
want to remove the garden hose, prepare a drip tray (not supplied) to collect the condensate from the drain outlet.
• Make sure that the height of the drain and section of the drain hose are not located higher than the drain outlet
on the air conditioner, or the continuous drainage may not work properly.
• In Cool or ECO mode, it is recommended to disable continuous drainage by replacing the drain cap onto the drain
outlet, to reach maximum performance.