Emerson QUIET KOOL EAPC8RD1 Owner's Manual page 16

The hose can be extended from its original length of 15" up to
59", but it is the best to keep the length to the minimum
required. In addition, make sure that the hose does not have
any sharp bends or sags. (Fig.7)
INSTALLATION INSTRUCTIONS
Installation of the window slider panel in a double-hung sash window
1. Cut the foam seals A (adhesive type) to the proper length and attach them to
the window and sill. (Fig.8)
2. Open the window sash and place the window slider kit on the window sill
(Fig.9). Attach the window slider kit to the window sill. Adjust the length of the
window slider kit according to the window's width. Attach two screws on the
window slider kit. See Fig.9.
Cut the adjustable window slider kit if the window's width is less than 26.6 inches
(Fig.10).
3.Close the window sash securely against the window slider kit. (Fig.11)
4.Drive two ½" screws to secure the window slider kit to the window sash.
(Fig.11)
5. Secure the window slider kit to the window sill (Fig.11):
A: For wooden window sill: use 3/4" screws.
B: For vinyl-clad windows: use ½" hex head cap screws.
6. To secure lower sash in place, attach right angle sash lock with ½" (12.7 mm)
screw as shown (Fig.12).
NOTE: It is difficult to lock the windows with the sash lock for vinyl-clad windows;
you can use lock by window itself.
7. Cut the foam seal B to an appropriate length and seal the open gap between the
top window sash and outer window sash, as shown in Fig.13.