Asus PRIME B560-PLUS Manual page 16

• ATX power button/soft-off button (2-pin PWR_SW)
This header is for the system power button. Pressing the power button turns the
system on or puts the system in sleep or soft-off mode depending on the operating
system settings. Pressing the power switch for more than four seconds while the
system is ON turns the system OFF.
• Reset button (2-pin RESET)
This 2-pin header is for the chassis-mounted reset button for system reboot without
turning off the system power.
• Chassis intrusion header (2-pin CHASSIS)
This header is for a chassis-mounted intrusion detection sensor or switch. Connect one
end of the chassis intrusion sensor or switch cable to this header. The chassis intrusion
sensor or switch sends a high-level signal to this connector when a chassis component
is removed or replaced. The signal is then generated as a chassis intrusion event.
18. Thunderbolt™ header
The Thunderbolt™ header allows you to connect an add-on
Thunderbolt™ I/O card that supports Intel®'s Thunderbolt™
Technology, allowing you to connect Thunderbolt™-enabled
devices and DisplayPort-enabled devices to form a daisy
chain-configuration.
•
•
1-6
E177887_PRIME_B560-PLUS_UM.indd 6 E177887_PRIME_B560-PLUS_UM.indd 6
The add-on Thunderbolt™ I/O card and Thunderbolt™
cables are purchased separately.
Please visit the official website of your purchased
Thunderbolt™ card for more details on compatibility.
TB_HEADER
PIN 1
Chapter 1: Product Introduction
2021/1/25 18:13:00 2021/1/25 18:13:00