Table of Contents
Advertisement
1
Install concealed ceiling system grid. Assemble the grid so there is a continuous
6-1/2" opening where luminaires will be installed. There must be at least 10" of
overhead space from ceiling line to properly install luminaires.
Note: Do not hang ceiling drywall before fixtures are installed. Luminaires must
be mounted prior to installation of ceiling to allow top access.
Ceiling Line
2
Determine number of Aircraft Cable Assemblies required.
Note: Refer to the diagrams on page 6 as a guide.
3
If applicable, assemble Aircraft Cable Assemblies. Install hex nuts about halfway
down each hex head bolt, then insert bolts through flat bracket and secure with
hex nuts.
Aircraft Cable
Cable Gripper
Hex Head Bolt
4
Determine locations where Aircraft Cables will be mounted overhead. Secure to a
sturdy surface, such as studs, using hardware (by others) that is rated for the
weight of the luminaire.
Note: Do not hang luminaire from weak material such as drywall or plywood.
5
Secure Aircraft Cable Assemblies to mounting surface. The top of the assembly
should rest approximately 7" above ceiling line. Ensure assembly is centered in
the opening. Adjust position of assembly along aircraft cable using cable gripper.
Do not trim excess cable at this time.
Mounting Surface
Cable Gripper
Ceiling Line
CALIFORNIA ACCENT LIGHTING, INC.
2820 E. Gretta Lane, Anaheim, CA 92806
ph. 800.921.CALI (2254) | fx. 714.535.7902 | info@calilighting.com | calilighting.com
© CALI. All rights reserved. CALI reserves the right to make changes or withdraw specifications without prior notice.
10"
Projected Location of
Hard Ceiling Drywall
6-1/2"
Hex Nut
Flat Bracket
Hex Nut
Aircraft Cable
~7"
Excess cable
ALS500T-DBR-MI
Mounting Luminaire (Aircraft Cable Assembly) 1 of 2
6
Adjust Cable Gripper by unscrewing locking mechanism. Press down and hold
the threads where cable feeds through. Pull cable from the exit. Let go of threads
to lock in place, then replace locking mechanism.
Unscrew & lift
7
Slide luminaires onto Aircraft Cable Assemblies. Adjust positioning of lower hex
nut if needed to allow assemblies to slide in easily. Always install corners first.
8
If applicable, install end cap to end of run.
INSTALLATION INSTRUCTIONS
Press down & hold
Pull cable
Slide fixtures onto
Aircraft Cable Assemblies
1 / 29 / 2021 / Rev 2
Page 4 of 11
Advertisement
Table of Contents
