Dell 6100 Hardware Manual page 9

Table 1. Microprocessor Module Jumper Settings
Jumper Setting
J6B1
J6D1
J4D1
J4B1
J1C1
jumpered
Table 2. Processor Frequency Select
Frequency SEL0 (Pins 1-2)
150/60 MHz No jumper
180/60 MHz Jumper
166/60 MHz No jumper
200/66 MHz Jumper
NOTE: A jumper is set on any of the three PARK settings (Pins 7-8, 9-10, or 11-12) for any
frequency selected.
Description
(default) A processor is not installed in the
adjacent slot, the SKIP setting. This
jumper is useful only when you are
using in-target probe (ITP).
A processor is installed in the adja-
cent slot, the INCLUDE setting.
(default) A processor is not installed in the
adjacent slot, the SKIP setting. This
jumper is useful only when you are
using ITP.
A processor is installed in the adja-
cent slot, the INCLUDE setting.
(default) A 200/66 MHz microprocessor is
installed. See Table 2 for jumper set-
tings by microprocessor speed.
(default) The fan heat sink jumper. Always set
to the default (passive).
The processor(s) cache is 1 MB.
The processor(s) cache is 512 KB.
unjumpered
SEL1 (Pins 3-4)
No jumper
No jumper
No jumper
No jumper
Dell PowerEdge 6100/200 System Microprocessor Replacement
SEL2 (Pins 5-6)
No jumper
No jumper
Jumper
Jumper
7