Advertisement
VOLTAGE
This light is universal voltage capable and can be operated with 100-277V AC, 50/60Hz. We also offer a low voltage version
of this LED fixture that operates on AC/DC voltages from 11-25 Volts.
MOUNTING
This hazardous location low bay LED light fixture comes standard with a wall-mount configuration. The mounting component
extends the fixture up to 6" from a flat, vertical mounting surface. Spacing between the mounting component and LED
fixture's fins, which are located at the back of the unit, streamline cool operation. This wall-mounting solution is ideal for
illumination directly above busy sections of facilities, work areas, doorways and more. Additionally, the mounting
configuration can facilitate accurate light placement over control stations, switchboards, panels and segregated sections of
work sites.
Several mounting options including pendant mounting, ceiling mounting and cable mounting can be ordered separately.
Compared to high bay lights, low bay fixtures are recommended for lower mounting heights ranging between 15' to 40'.
WIRING
The hazardous location low bay LED light fixture is equipped with an internal wiring junction box built into the mount of the
fixture. A total of four, 3/4" NPT threaded ports are available for running conduit (located at every corner of the unit).
Additionally, wiring can be passed through the junction box, reducing the need for additional junction boxes. Operators run
wiring directly to the fixture and terminate in the junction box mount. This fixture is factory sealed and does not require a seal
off.
MAINTENANCE
Caution: To avoid personal injury, disconnect power to the light and allow the unit to cool down before
performing maintenance.
Warning: No user serviceable parts inside of fixture. Risk of electric shock. Removal of the lens will void
the warranty.
1. Perform visual, mechanical and electrical inspections on a regular basis. We recommend routine
checks to be made on a yearly basis. Frequency of use and environment should determine this. It is
recommended to follow an Electrical Preventive Maintenance Program as described in NFPA 70B:
Recommended practice for Electrical Equipment.
2. The lens should be cleaned periodically as needed to ensure continued photometric performance.
Clean the lens with a damp, non-abrasive, lint-free cloth. If not sufficient, use mild soap or a liquid
cleaner.
3. Inspect the cooling fins on the luminaire to ensure that they are free of any obstructions or
contamination (i.e. excessive dust build-up). Clean with a non-abrasive cloth if needed.
4. Do not operate if the lens is cracked or damaged. All fasteners should be properly seated.
Larson Electronics, LLC
WARNING: CHECK NAMEPLATE
FOR PROPER VOLTAGE. DAMAGE
FROM IMPROPER VOLTAGE WILL
VOID WARRANTY.
Phone: (800) 369-6671
Fax: (903) 498-3364
EPLC2-LB-45LED-RT-WLM
www.larsonelectronics.com
2 of 2
Advertisement
