Maintenance Information For Miranit-S; Cleaning The Shower Head Faceplate; Replacing The Filters - Franke AQUALINE-Therm AQLT0109 Installation And Operating Instructions Manual

19. Maintenance information for MIRANIT-S

Soap cleaners with a neutral pH-value are sufficient for cleaning and care. Apply the
cleaner with a soft, clean cloth, leave to soak briefly and then rinse with a large
volume of water.
Caution!
The following must not be used:
• Cleaning agents with an abrasive effect
• Cleaning sponges / cleaning cloths with an abrasive effect
• Steel wool or other hard objects
• Solvents
☞
Important!
Possible minor damage to the surface, e.g. small scratches, can be directly polished
out. A repair kit is available for larger damaged areas. The surface is polished with
Type 1000 grinding paper after application and drying of the repair material.

20. Cleaning the shower head faceplate

20.1 Release the screw using an Allen key.
20.2 With a screwdriver, carefully lever out the spray faceplate.
20.3 Clean the shower head faceplate.
20.4 Reassemble in reverse order.

21. Replacing the filters

Water volume regulator filters
21.1 Remove the shower panel (see
21.2 Unscrew the locking screws (a) on the water volume regulators.
21.3 Replace the filters (b).
☞
Important!
Note the installation position of the filters.
21.4 Reassemble in reverse order.
Chapter 18.).
- 11 -