Replace a CRU
Follow the replacement procedure to replace a CRU.
Base cover assembly
Prerequisite
Before you start, read Generic Safety and Compliance Notices and print the following instructions.
Note: There might be a risk of short circuits if you remove the base cover assembly when your computer is
connected to ac power.
Replacement procedure
1. Disable the built-in battery. See "Disable the built-in battery" on page 35.
2. Turn off the computer and disconnect the computer from ac power and all connected cables.
3. Close the computer display and turn over the computer.
4. Loosen the screws that secure the base cover assembly
shown
2
and remove the base cover assembly
36
T14s Gen 1 and X13 Gen 1 User Guide
1
. Push the base cover assembly forward as
3
.