AEG PROFI-FOEN HTD 5649 Instruction Manual page 25

• Connect the appliance to a properly installed earthed
socket.
Use
Slide the switch on the handle to the desired heat / blower
setting:
Position 0: off
Position 1: gentle air flow and medium temperature
Position 2: strong air flow and high temperature
COOL SHOT (Cold Air)
Switch : With this switch you can stop the heating pro-
cess.
Hold the button down in this position according to the de-
sired interval length. When the button is released it returned
automatically to the initial position.
Maintenance and care
WARNING:
• Before cleaning remove the mains lead from the socked.
• Under no circumstances should you immerse the device in water
for cleaning purposes. Otherwise this might result in an electric
shock or fire.
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
Clean the housing with a soft, dry cloth without additivesl.
Air Intake Grill
Please clean the grill on the air intake side of the hairdryer
regularly in order to avoid excessive temperatures as a result
of heat accumulation.
• Unscrew the grille in an anticlockwise direction.
• Remove any dirt that is present.
• If necessary, a fine brush can be used.
• Turn the grille tight in a clockwise direction.
Ionisation function – reducing electrically charged hair
The dryer is also equipped with an ioniser, which when
switched on gives off negative ions with the air that is ex-
pelled. This process helps to protect the hair when it is being
dried while simultaneously helping to improve hair structure,
increase the volume of the hair, produce a silky sheen and
also reduce the static charge of the hair.
This process is particularly gentle for stressed hair.
Switch-off
After use, slide the switch to position "0" and disconnect
from the mains.
Storage
• Leave the device to cool before putting it away!
• To do so, place the appliance onto one side of the hous-
ing or hang it up by the suspension eye.
• For a space-saving storage the handle can be rotated in.
Mains Cable
• The mains cable should only be wound up loosely.
• Never tie the cable tightly round the device, as over time
this may result in the cable breaking.
• Check the mains cable regularly for damagen.
Noise development
The sound pressure level in the ear of an operator (LpA) was
measured according to DIN EN ISO 3744.
Sound pressure level detected: 80 dB(A) (no limit)
Technical Data
Model: ................................................................................HTD 5649
Power supply: ............................................... 220-240 V~; 50/60 Hz
Power consumption:.................................................. 2200 W max.
Protection class: ................................................................................II
Net weight: .............................................................................0.53 kg
The right to make technical and design modifications in
the course of continuous product development remains
reserved.
English
25