Advertisement
2
e ink cartridges, and remove them from the
Gently shake th
packaging.
3
Remove only the yellow tape from each ink cartridge.
Caution:
Do not remove any seals, or ink will leak. Do not touch
the areas shown above. Doing so may prevent normal operation
and printing.
4
Insert the cartridge in the holder for each color. Press each
cartridge down until it clicks. Make sure all cartridges are
pushed down into place.
5
Close the ink cartridge cover, then lower the scanner unit.
6
The product starts charging the ink. Ink charging takes
approximately 5 minutes. When you see a completion
message on the product's LCD screen, charging is
complete.
Caution:
Don't turn off the printer or raise the scanner unit while
the printer is charging or you'll waste ink.
4
Load paper
See the online User's Guide for information about loading
capacity, available paper types and sizes, loading envelopes,
and using the rear paper feed slot or ADF.
1
Make sure the product is done charging the ink, then pull
out the paper cassette.
2
Slide the side edge guides all the way out and set the
front edge guide to the paper size you are using.
3
Insert paper with the glossy or printable side down.
Note:
Make sure the paper is under the arrow mark for your
paper type and loaded against the front edge of the cassette.
4
Slide the edge guides against the paper, but not too
tightly.
5
Keep the cassette flat as you insert it all the way.
6
Select the paper settings on the product's control panel.
Advertisement
