Dell XPS Gen 3 Owner's Manual page 86

4
Install the hard drive into the computer by gently sliding the drive into place until the tabs
securely click into position.
NOTE:
If you are installing a hard drive in the lower bay, place the drive in the bay so that the power
connector is on the left-hand side (opposite of the top hard drive)
.
5
Connect a power cable to the drive.
6
Connect the hard-drive cable to the drive and to the system board (see page 69).
7
Check all connectors to be certain that they are properly cabled and firmly seated.
NOTICE:
8
Insert the bottom tabs of the shroud in to the holes on the drive cage and rotate the
shroud up.
9
Press in on the top tabs and lock them in to place.
10
Gently press on the shroud to ensure it is secure.
86
Removing and Installing Parts
hard-drive cable
power cable
When replacing the hard-drive shroud, ensure that all the cables are properly routed.
tabs (2)
hard drive
system board connector