Advertisement
1
3
4 x
Cutting shaft to desired length
5
3
Handle and shaft are factory assembled as one unit.
To facilitate cutting of shaft to desired length,
use a 3 mm (0.12") hex wrench or driver to loosen
inner screw at base of handle and remove handle
and shaft unit from housing.
8
Fasten door-mounted handle coupling piece
(supplied as part of the kit) to other end of shaft as shown.
2/3
6
1
2
3 mm
9
3 mm
2 Nm
(17.7 lb-in)
2
4
1
Cut to desired length
2
Smooth out cut end
Emergency On Call Service: Local representative (www.eaton.eu/aftersales) or +49 (0) 180 5 223822 (de, en)
36 mm
g0.5 mm
(1.42"
g0.02"
Re-installing handle and shaft
7
1
Re-install handle and shaft unit after cutting,
and re-tighten inner hex screw as shown.
10
23 mm g1
(0.91" g0.04")
)
2
3
3 mm
2.5 Nm
(22 lb-in)
Advertisement
