Remove The Transit Bars; Starting The Calibration Programme - Miele WWG 360 Operating Instructions Manual

Before using for the first time

3. Remove the transit bars


Damage resulting from failure to
remove the transit bars.
Failure to remove the transit bars can
result in damage to the washing ma-
chine and to adjacent cabinetry or
appliances.
Remove the transit bars as described
in "Installation and connection".
The following message appears in the
display:

Remove transit bars
 Confirm with the OK sensor control.
4. Starting the calibration pro-
gramme
For optimum water and energy con-
sumption and excellent wash results, it
is important to calibrate the washing
machine.
To do this, the Cottons programme
must be run without laundry and
without detergent.
No other programmes can be started
until calibration has been carried out.
The following message appears in the
display:
Open  and run "Cottons 90°C" without
laundry.
 Touch the  sensor control until the
OK sensor control lights up and con-
firm with OK.
20
 
90°
1400
 
 Open the stopcock.
 Touch the Start/Add laundry sensor
control.
The calibration programme then starts.
It will take approximately 2 hours.
At the end of the programme, the fol-
lowing message will appear in the dis-
play:

Set up complete
 Take hold of the door and pull it
open.
Tip: Leave the door slightly open to al-
low the drum to dry.
 Turn the programme selector to the
 position.
1:55
OK