Table of Contents
Advertisement
2.2 Names and Functions of Parts of Main Unit
No.
Name
POWER switch
LED lamps
OPERATION
LOW BATTERY
ZERO ADJ
Input part
Output part
Battery case
Back label
Chapter 2 Names and Functions of Parts
Description
Turns this instrument on and off.
This instrument is turned on when this slide
switch is moved to the I side and is turned off
when moved to the O side.
This instrument operates with four AA dry
batteries placed in its back (battery case ).
Indicates the operating condition of the power
supply of this instrument. Comes on green when
this instrument is turned on and comes off when
turned off.
Indicates the state of AA dry batteries. This lamp
turns yellow when the batteries are consumed.
Replace them when the lamp lights up yellow.
Used to adjust the zero point of the output .
There is a hole for zero point adjustment on the
side of ZERO ADJ. Insert the accessory screw
driver into the hole to perform zero point
adjustment.
The sensor cable (refer to Section 2.3) integral
with the main unit is connected to this part.
BNC output connector.
Outputs the voltage (current waveform) of the
main unit.
Located on the back of the main unit and used
to house four AA dry batteries. To open this
battery case, push its lid downward. Place the
batteries in this case while paying attention to
their orientation, and then close the lid.
There is a label placed on the back of the main
unit.
The label describes the following:
• TYPE: One of the eight models, SS-293S/L,
294S/L, 295S/L, 296S/L
• Peak Current: One of the current values that
the above model handles, 1.2 kA, 3 kA,
6 kA, or 12 kA
• Sensitivity: Voltage sensitivity (mV/A) of the
current that the above model handles.
• S/N: 11-digit serial number
Reference
► Section 4.2
► Section 4.2
► Section 2.1
► Section 2.1
► Section 2.1
► Section 2.1
13
Advertisement
Table of Contents
