Valcom VE8011 Manual

NETWORKED STATION PORT
INTRODUCTION
The VE8011/VE8011R Networked Station Port
allows most loop start terminal devices to be
connected to a managed IP-based LAN/WAN.
The VE8011 is designed for wall or table placement.
The VE8011R is designed for 19" rack mounting (1U).
SPECIFICATIONS
Access Methods

PBX, FXO Port

POTS telephone set
Features

RJ-45 for network connection

1 RJ-11 telephone connections

2 Relays with Form C contacts

Front panel activity LED

Network activity LEDs

2 REN

2.5mm jack for DC

Power over Ethernet 802.3af compatible
Dimensions/Weight (VE8011)

1.38 H x 6.13" W x 5.25" D
(3.50cm H x 15.6cm W x 13.33cm D)

Weight: 1.25 lbs. (0.57 kg)
Dimensions/Weight (VE8011R)

1 Standard 19" Rack Unit

1.75 H x 16.50" W x 5.25" D
(4.45cm H x 41.91cm W x 13.33cm D)

Weight: 5.10 lbs. (2.32 kg)
Nominal Specifications
Input Impedance:
Input Level:
Output Impedance:
Output Level:
Relay Current:
Nominal Power Requirements
Via rear panel barrel connector:
Voltage:
Current:
Via 802.3af PoE Ethernet Switch:
802.3af:
VE8011, VE8011R
600 Ohms
-10dBm
600 Ohms
- 10dBm nominal
1 AMP @ 24VDC
24VDC
325mA
Class 3
1
VE8011
VE8011R
Environment
Temperature:
Humidity: 0 to 85% non-precipitating
INSTALLATION
NOTE: The telephone system referred to in
this manual is the customer premise
equipment such as an electronic key system,
a PBX or a dedicated single line telephone
sets. The VE8011/VE8011R is not intended for
direct or indirect connection to the public
telephone network. When used with a
customer premise telephone system such as
a key system or PBX system, these units are
interfaced to the system via a fully protected
trunk port or system central office port, which
is a fully protected interface device. Also, the
host system must be configured to disallow
central office trunk conferencing in order to
prevent indirect connection to the public
network.
Issue 4
0 to +40° C
947654