8
Connect the floppy-drive power cable to the back of the drive.
CAUTION:
9
Connect the data cable to the back of the drive and to the floppy drive connector on the
system board (see page 51).
10
Position the top of the floppy drive bracket so that it is completely flush with the bottom of
the upper drive bay, and then slide the floppy drive bracket forward into place.
NOTE:
The top of the floppy drive bracket has two slots that fit into two clips on the bottom of the upper
drive bay. When the floppy drive bracket is properly mounted, it remains in place without support.
56
Removing and Installing Parts
tabs (2)
insert
Match the colored strip on the cable with pin 1 on the drive (pin 1 is marked as "1").