Delfield Shelleymatic T-1221H Specifications

Short form specifications
Cabinet top shall be 16-gauge stainless steel with all corners
welded, polished and reinforced with heavy-gauge channels.
Cabinet exterior panels shall be 20-gauge stainless steel.
Bottom shall be 14-gauge galvanized steel. Unit shall have (4)
4.00" (10.2cm) diameter polyolefin swivel casters (all locking),
and non-marking gray bumpers at each corner.
Dispenser platform carrier shall be 18-gauge stainless steel
and shall be removable for cleaning. Each dispenser shall be
field adjustable by adding or removing stainless steel extension
springs located inside the elevator housing.
THE FOLLOWING APPLIES TO T/T2-H HEATED DISPENSERS
ONLY:
Heated dispensers shall have a stainless steel liner separated
from the outer panels by 2.00" (5.1cm) of fiberglass insulation.
Unit shall be supplied with 9' (2.7m) cord and plug as shown in
the specifications table on reverse. Electrical connections shall
be 120 volt, 60 hertz, and single phase.
Dispenser shall have one or two convection heating modules
consisting of a single 700-watt heating element and fan motor,
located in the center of the interior bottom cavity. Models
1014-1422 shall have one module; larger models have two
modules. Air intake shall have a filter. Dispenser shall have an
adjustable thermostat and an ON/OFF switch on the side of the
unit. Unit shall maintain a temperature between 150°F-170°F
(66°C-77°C).
The Delfield Company, 980 S. Isabella Rd., Mt. Pleasant, MI 48858, U.S.A. • (800) 733-8821 • Fax (800) 669-0619 • www.delfield.com
Delfield reserves the right to make changes in design or specifications without prior notice. ©2002 The Delfield Company. All rights reserved. Printed in U.S.A.
PROJECT
ITEM #
QUANTITY
APPROVAL
Mobile enclosed tray and rack dispensers
MODEL TG-1216
Optional Accessories & Modifications
Heavy-duty caster (consult factory)
•
Flange-mount feet in lieu of casters
•
Special tray dispenser sizes
•
Six- or eight-hole silverware bins with
•
plastic or stainless steel cylinders
Additional plastic or stainless steel
•
silverware cylinders
Wrap-around bumpers (adds 1.75"
•
[4.4cm] to overall length and depth)
Fiberglass panels
•
Laminate panels
•
Special tray & rack sizes
•
Special height
•
DATE
T