Glass Replacement Procedures - Invicta AARON Owner's Manual

Ensure that the baffle pieces are pushed together at
the center joint.
CAUTION - Do not force the baffle pieces. Gently
adjust the baffle orientation until each side can be
removed freely from the stove.

GLASS REPLACEMENT PROCEDURES

WARNING : DO NOT OPERATE THIS APPLIANCE WITH
THE GLASS PANEL REMOVED, CRACKED, OR
BROKEN. DO NOT SUBJECT THE DOOR TO ABUSE,
SUCH AS STRIKING OR SLAMMING SHUT. ONLY A
QUALIFIED SERVICE PERSON SHOULD REPLACE
THE GLASS PANEL.
1. Follow the instructions included with the replacement
glass kit.
2. Remove the screws from the glass clips (use
penetrating oil if necessary) – Set aside for
reinstallation.
3. Carefully lift the damaged glass off the door and
discard.
4. Remove any remaining glass and old gasket
material.
5. Clean the screw holes and place a small amount of
anti-seize compound in each one.
6. Install a new glass gasket in the glass gasket groove.
7. Place the new glass onto the door.
8. Important! Center the glass and ensure that the
edges of the glass are parallel with the edges of the
opening.
9. Check glass position again (centered, and parallel),
then screw the glass retainer clips with the glass pads
back on the door using a crisscross pattern. Tighten
the screws no more than 1/8
The glass will break at this point if not positioned
correctly.
10. Apply a light film of anti-seize lubricant on the door's
hinge pins if needed.
11. After 5 or 6 fires, check the glass retainer screws, and
retighten if necessary. Use only 4mm x 329mm x
395mm Ceramic, or
Neoceram glass. Contact your INVICTA dealer.
Energy Distribution 2015
th of a turn after they seat.
REVISION JULY 2020
Figure 20 : Front Door assembly
21