Preparing Media - Panasonic SC-AKX710 Operating Instructions Manual

Preparing media

Disc
1
Press [x] on main unit to open the disc tray.
Put in a disc with the label facing up.
Press again to close the disc tray.
2
Press [SELECT <, >] repeatedly to select "CD".
USB
Preparation
Before you connect a USB device to the system, make
sure you do a backup of the data.
1
Decrease the volume and connect the USB device
to the USB port.
Hold the main unit when connecting or disconnecting
the USB device.
2
Press [SELECT <, >] repeatedly to select "USB A"
or "USB B".
USB status indicator lights up in red when selected.
Note:
•
Do not use a USB extension cable. The system cannot
recognise USB device connected through a cable.
•
Some devices cannot be charged as the maximum USB
charging current is 500 mA only.
Bluetooth
®
You can connect and play an audio device wirelessly
through Bluetooth .
®
Preparation
• Switch on the main unit.
• Switch on the Bluetooth
the device near the system.
• Read the operating instructions of the device for details.
█ Pairing a device
Preparation
If this system is connected to a Bluetooth
disconnect it ( 8).
1
Press [ ].
If "PAIRING" is shown, continue with step 3.
2
Press [PLAY MENU] repeatedly to select
"PAIRING" and then press [OK].
3
Select "SC-AKX710" from the Bluetooth
the device.
If prompted for a passkey, input "0000" or "1234".
The device connects with this system automatically
after pairing is complete.
The MAC address (example: 6C:5A:B5:B3:1D:0F)
may be shown before "SC-AKX710" is shown.
The name of the connected device is shown for a few
seconds.
8
8
feature of the device and put
®
device,
®
menu of
®
Using the main unit
1
Press and hold [
2
Select "SC-AKX710" from the Bluetooth
the device.
Note:
You can pair up to 8 devices with this system. If a 9th device is
paired, the device that has not been used for the longest time
will be replaced.
█ Connecting a device
Preparation
If this system is connected to a Bluetooth
disconnect it ( 8).
1
Press [ ].
"BLUETOOTH READY" is shown.
2
Select "SC-AKX710" from the Bluetooth
the device.
The name of the connected device is shown for a few
seconds.
3
Start playback on the device.
Note:
•
A device must be paired to connect.
•
This system can only connect to one device at a time.
•
When "BLUETOOTH" is selected as the source, this system
will automatically try to connect to the last connected
device. ("LINKING" is shown during this process.)
█ Disconnecting a device
While a Bluetooth device is connected
®
1
Press [PLAY MENU] repeatedly to select
"DISCONNECT?".
2
Press [Y, U] to select "OK? YES" and then press
[OK].
"BLUETOOTH READY" is shown.
To cancel, select "OK? NO".
Using the main unit
Press and hold [ ] until "PAIRING" is shown.
Note:
A device is disconnected when you:
•
Select a different source.
•
Move the device out of the maximum range.
•
Disable the Bluetooth transmission of the device.
®
•
Switch off the system or the device.
] until "PAIRING" is shown.
menu of
®
device,
®
menu of
®