Connecting The Water Hose - Banzai AQUA SPORTS WATER PARK 90350 Manual

Water park

Hide thumbs

Table Of Contents

Table of Contents

THE AQUA SPORTS WATER PARK™ SETUP DIAGRAM

Water Spraying

Blower Motor

Hose Assembly

Water Slide

Blower Motor

Ground Stakes

1. Wet the inflatable before connecting the garden hose to the hose

Water Spraying

adapter.

Hose Assembly

2. Locate the end of the Water Spraying Hose Assembly that should be

attached to the inflatable.

3. Attach the screw cap on the hose assembly to your garden hose.

4. Turn on the water slowly. It may take a few moments until water begins

to spray.

5. Adjust the water pressure so that the water sprays on the sliding

surface of the inflatable, keeping the inflatable wet.

Water pressure can vary dramatically between cities. Please read

the following to answer some common questions.

Areas of LOW WATER PRESSURE:

• For maximum performance, it is recommended to use a

5/8 in (1.6 cm) diameter garden hose.

• If water does not arch on the slide or shoot properly. This is

usually due to low water pressure, make sure the water is on all

the way. As long as the slide is getting wet, it will be fun to use.

• Long hoses reduce water pressure: The longer the hose, the

farther the water travels from the faucet thus reducing water

pressure. In areas of low water pressure, this could affect

performance of the water spray. Try using a shorter hose if you

have one.

Areas of HIGH WATER PRESSURE:

• If water shoots over the slide, adjust the faucet to lower the

water pressure. It is important that the water lands on the slide

to keep it wet and slick.