Care And Maintenance - Garden Treasures MZ14027GA Assembly Instructions Manual

CARE AND MAINTENANCE

 Check regularly that the water reservoir has sufficient water to cover the pump at all times. It will be
necessary to check more frequently in warm or windy weather.
 Do not allow the pump to freeze. During cold spells, remove the pump from the water feature and
place in a water-filled container in a frost-free position. DO NOT store the pump dry.
 Periodically it will be necessary to change the water and clean the water feature and reservoir. The
frequency of this will depend on the weather and location of the water feature. The outside of the
water feature can be cleaned using a soft cloth and clean water and the reservoir with a soft brush.
A mild detergent can be used, but please note this will cause the water to foam and should be
avoided unless strictly necessary.
 The pump rotor will require cleaning at approximately monthly intervals. A good indication will be if
the water flow rate drops. Unplug the water feature, remove the pump from the water reservoir and
disconnect the water pipe. Remove the filtering cover and pressure-casing from the front of pump
body. Clean the rotor and housing in clean water using cotton buds. Reassemble the pump,
reconnect the water pipe and reassemble the water feature.
Replacing the light.

Step 1: Unfold the light clamp gently
to remove light from the fountain
body.
Step 2: Take off the light.
5
Step 3: Insert a new light into the light clamp.
NOTE: To acquire replacement lights, please
refer to the Replacement Parts section. Only
use the lights available for order there as
replacements.