PROAQUA WATER TUBE CURBITZ II Manual page 8

Inflating the product
1. Spread the product out on a flat surface.
2. Inflate air chamber 1 first, via air valve 1.
Close the air valve and press it down.
3. Once air chamber 1 has been inflated, fit the protection
cover over the floatation ring making sure that the opening
flap is lined up over air valve 2.
4. Air valve 2 is a screw valve consisting of an inner valve
body and an outer valve cap, the inner valve body
contains a non-return valve. Unscrew the outer valve cap
from air valve 2 and fill the chamber with air. Only use a
foot pump or electric pump designed for the inflation of
floating leisure articles. Never use an air compressor.
5. Do not over-inflate the product as too high a pressure could damage it and compromise safety.
6. Screw the outer valve cap back on again. Check that no air is leaking out.
Deflating the product
1. Open air valve 1 and let the air out.
2. Unscrew the entire inner valve body of air valve 2 and
let the air out.
3. Roll the product up to squeeze all the air out.
Towing attachment
• Use a tow rope of at least 1500 lbs. average tensile strength for pulling a single person
• The tow rope should be at least 50 feet in length, but not exceed 65 feet. Attach your towable
to the tow rope using the quick connect attachment.
8
English
1 1
2 2