Introduction; Intended Use; Features; Assembly Instructions - aidapt VA141 Fixing And Maintenance Instructions

INTRODUCTION

Thank you for purchasing the Folding Ramp from Aidapt.
These instructions should be read carefully and left with the user of the product for future reference.
Please ensure this equipment is installed/used by a competent person.
VA141 – Roll Up Ramp 300kgs (47.2 St.) MAX Weight Load
Do not exceed the weight limit stated – doing so could put you at risk.

INTENDED USE

The Folding Ramp from Aidapt is a compact, folding, aluminium ramp for easy access to houses and cars for wheelchairs and
scooters.

FEATURES

•
Portable, compact design that is quick to install
•
Supplied with a bag
•
Allows easy access to houses and cars

ASSEMBLY INSTRUCTIONS

Please examine your product for any visible damage before using/installing. If you see any damage or suspect a fault, please
do not use, but contact your supplier.
1. The ramp should be fully rolled out and the side locked and must be securely in place before use.
2. Select a place to use where the ramps have the minimum gradient possible. Ensure the gradient of the ramps is not
beyond the ability of the wheelchair or occupant. The maximum gradient is 1 in 12.
3. Ensure the ramp is fully assembled and the front of the ramp is placed upon the step or obstacle being climbed (the
front of the ramp is identifiable due to the cut out edges on either side).
4. Ensure the ramps are safe before use.
TO ROLL OUT
•
To begin, roll out the main section of the ramp and check to ensure it's straight.
•
Attach the side sections ensuring the fastening clips are correctly locked into place (the locking pin end of the side rail
should be at the same end of the holes for the locking pin).
•
Check the ramp is correctly assembled.
TO ROLL UP
•
Release the latches securing the side sections to the ramp.
•
Remove the side sections and roll up the main section of the ramp
•
Ramp can be securely placed into provided carrier bag for easy storage.
MAINTENANCE & SAFETY
•
Regularly check your ramp for worn, loose or damaged parts – If you find any of these to be damaged you must not
use your ramp and you must contact your dealer immediately.
•
Ensure ramp is fully extended and locked in position before use.
•
Do not attempt to use ramps on gradients above 1 in 12. Please also check the gradient your wheelchair or scooter is
capable of.
•
Do not exceed the weight capacity of the ramp.
•
Only allow one person/ mobility vehicle to use the ramp at once.
•
The surface of the ramp may become slippery in icy or wet conditions. Please exercise caution in these conditions.
•
Keep your ramp clean of any dirt or debris as this could interfere with its sliding motion.
•
Always use the ramp in line with the wheelchairs/scooter manufacturer's guidelines; NEVER use it at a steeper
gradient than recommended.
•
Do not modify or add to your ramp as it could void any warranty claims.
•
Do not use the ramp for anything other than its original intended purpose.
•
Only clean your ramp with a mild detergent and ensure it is dry before use.