Barbeques Galore Turbo TSB10ALP Operator's Manual page 9

4
Install Partition Panel (for TSB10ALP Model)
Install the Partition Panel (not included in this unit)
Make sure there is 22-24'' of clearance between the partition panel and the Tank Holder
Assembly.
5
Side Burner Electrode Check
This test will ensure that the Spark Electrode
Tips are properly positioned so your Side
Burner lights easily and properly.
Be sure that both Control Knobs are set to
"OFF" and open the Side Burner Lid.
Press the Ignitor Cap. You should hear a
"clicking" sound. Your assistant should see
a blue spark within each Spark Electrode
Tip . If a spark is present the Electrode Tips
are properly positioned.
If no spark is seen, the Spark Gap needs
to be adjusted as follows:
•
If the gap between the Spark Electrode Tip
and Burner Port is more than 3/16" wide
use needle nose pliers to gently squeeze
the Spark Electrode Tip to narrow gap.
•
Recheck the Electrode again, if no "clicking"
sound is heard:
-
AA Battery may be installed backwards.
-
Electric wires may be loose. Remove the AA
Battery and inspect the Ignitor Junction Box
found behind the Control Panel and recon-
nect any loose wires.
WARNING
!
Failure to remove Side Burner Lid during the lighting
procedures could result in a fire or explosion that
could cause serious bodily injury, death, or property
damage.
Partition Panel
(above the Gas Tank)
3/16"
Spark Gap
Spark Electrode Tip
Burner Port
!
onto the left island.
5"
5"
1"
Install Cooking Components
6
Position the Pot Support over the Burners.
Place the Side Burner Lid over the Pot
Support.
Pot Support
Lid
Final Side Burner Assembly
When you have finished assembling your side
burner, be sure that all screws are tightened
for safe operation of your side burner.
Before each use of the side burner, make sure
the Grease Tray is fully seated under the side
burner Bowl.
CAUTION: The Grease Tray should be inspected
before each side burner use to be sure there
is no excessive grease buildup. Clean the
Grease Tray frequently to eliminate grease
build-up and to prevent grease fires.
9
Vent Openings must
be at least 1/8" wide.
22-24"
21"
17-19"
2"
Fig. 4
Step