Assembly Instructions - Barbeques Galore Turbo TSB10ALP Operator's Manual

Liquid propane/natural gas side burner

Hide thumbs

Table Of Contents

Table of Contents

CAUTION:

You will need to build the island unit before assembling the side burner. Refer to pages 9-11 for dimen-

sions information. Obtain assistance from another person when assembling the side burner and installing it into an

island unit.

Install Side Burner Lid Knob and Ignitor Battery

Open the Side Burner Lid.

Remove the Phillips Head Screw 3/16''x3/8'' from the Side Burner Lid Knob.

Align the hole on the Side Burner Lid and the hole on the Side Burner Lid Knob. From the underside

of the Side Burner Lid, insert the Phillips Head Screw 3/16''x3/8'' and tighten securely.

Remove Ignitor Cap from Control Panel.

Place supplied AA battery into the Ignitor Slot with positive pole facing you.

Position the Cap and Spring over the AA battery and tighten onto Control Panel.

Lid Knob

Qty. 1

Part # P00215038A

Phillips Head Screw

3/16"x3/8"

Qty. 1

Part # S112G03061

Install NG Regulator and 12 Foot Hose (For TSB10ANG Model)

Note: You will need to make 5 holes large enough for installing hardware in your Island Side Panel.

3 of the holes will be needed for installing the NG Regulator Bracket. 2 holes will be needed for

installing 2 screws for the Hose Holder. You will also need to make 1 hole large enough for the

Regulator Hose to fit through the Island Side Panel.

Connect the NG Regulator fitting (see diagram) onto the Gas Manifold. Install the Hose Holder onto

your Island Side Panel using 2 Phillips Head Screws 3/16''x3/8'' and tighten using 2 Flange Nuts

3/16''. Make sure to place the NG Regulator hose into the Hose Holder.

Install the NG Regulator Bracket onto your Island Side Panel using 3 Phillips Head Screws

3/16''x1/2''. Tighten 3 Flange Nuts 3/16'' onto the ends of the 3 Phillips Head Screws as shown.

Place the NG Regulator into the NG Regulator Bracket.

Connect the Swivel Nut of the 12 Foot Hose (not included in this unit) onto the NG Gas Regulator.

Phillips Head Screw

3/16"x3/8"

Qty. 2 (For NG model)

Part # S112G03061

Phillips Head Screw

3/16"x1/2"

Qty. 3 (For NG model)

Part # S112G03081

Flange Nut 3/16"

Qty. 5 (For NG model)

Part # S313G03051

Hose Holder

Qty. 1

Part # P05536001A