Table of Contents
Advertisement
4
Install Ignitor Battery
Remove Ignitor Cap from Control Panel.
Pl ac e s uppl i ed AA bat t er y i nt o t he I gni t or
Sl ot wi t h pos i t i v e pol e f aci ng y ou.
I ns t al l t he Cap and Spr i ng ov er t he AA
bat t er y and t i ght en s ec ur el y .
Ignitor Slot
AA Battery
Ignitor Cap
+
5
Side Burner Electrode Check
This test will ensure that the Spark Electrode
Tips are properly positioned so your Side
Burner lights easily and properly.
Be sure that both Control Knobs are set to
"OFF" and open the Side Burner Lid.
Press the Ignitor Cap. You should hear a
"clicking" sound and see a blue spark within
each Electrode Tip. If a spark is present the
Electrode Tips are properly positioned.
If no spark is seen, the Spark Gap needs
to be adjusted as follows:
•
If the gap between the Spark Electrode Tip
and Burner Port is more than 3/16" wide
use needle nose pliers to gently squeeze
the Spark Electrode Tip to narrow gap.
•
Recheck the Electrode again, if no "clicking"
sound is heard:
-
AA Battery may be installed backwards.
-
Electric wires may be loose. Remove the AA
Battery and inspect the Ignitor Junction Box
found behind the Control Panel and reconnect
any loose wires.
3/16" Spark Gap
Spark
Electrode Tip
WARNING
!
Failure to open Side Burner Lid during the lighting
procedures could result in a fire or explosion that
could cause serious bodily injury, death, or property
damage.
-
Spring
Burner Port
Install Cooking Components
6
Side Burner Cap
Final Side Burner Assembly
When you have finished assembling your side
burner, be sure that all screws are tightened
for safe operation of your side burner.
Before each use of the side burner, make sure
the Grease Tray is fully seated under the Side
Burner Body.
CAUTION:
!
inspect the Grease Tray and inside of the Side
Burner Body to be sure there is no excessive
grease and debris buildup. Clean the Grease Tray
and inside of the Side Burner Body
frequently to eliminate grease/debris build-up
and to prevent grease fires.
9
Place the Side Burner Caps over the Side
Burners.
Position the Pot Support above the Side
Burner Body.
Pot Support
Step
Before each use of your Side Burner,
Advertisement
Table of Contents
