Table of Contents
Advertisement
3-1
For LP model(BTESB14ALP), install Regulator, Tank Tray Set and Liquid Propane(LP) Gas
Tank
Note: Regarding the connector, for safety, we suggest using a stainless steel flexible connector. But,
if using semi-rigid tubing, do not use materials made of aluminum or aluminum alloy tubing. The connector
should be installed at a location visible when opening the door.
On the proper location, drill 2 threaded holes on the island left side panel for installing the regulator
hose connector. Then install the regulator hose connector using 2 Pan Head Screws 3/16"x3/8" and tighten
securely.
On the proper location, drill 3 threaded holes on the island left bottom panel for installing the tank tray
set. Then install tank tray set using 3 Pan Head Screws 3/16"x3/8" and tighten securely.
Connect one end of the stainless steel flexible connector to the gas manifold and the other end to regulator
hose connector. Then use a clamp to hold the stainless steel flexible connector as shown to secure.
Place the LP gas tank into the tank tray set. Make sure the tank valve facing the right rear corner of left
island. Tighten the wing bolt to secure the LP gas tank. ( See Fig. 2)
Connect the LP regulator onto the LP gas tank.(Refer to page 12)
CAUTION: There shall be a minimum clearance of 2 inches (50.8 mm) between the floor of the LP-gas cylinder
enclosure and the ground.
Pan Head Screw
3/16"x3/8"
Qty. 5
Part # S182G03061
Stainless Steel Flexible Connector
(Not provided) must comply with the
Standard for connectors for Outdoor Gas
Appliances and Manufactured Homes,
ANSI Z21.75•CSA 6.27, and suitable for
outside installation.
The maximum length of the connection
shall be 6ft.(1.82m).
For LP model(BTESB14ALP), install Partition Panel
3-2
The gas grill is designed for use with a maximum of 20 lb tank. As per standard, a partition
panel (not included) or equivalent device is required to be installed in the left cabinet of the island
for preventing the use of 30 lb tank. (See Fig.3)
Note: Make sure there is 22~24" of clearance between the partition panel and tank tray set. The
space around the gas tank is not greater than 12".
clamp
(Not provided)
LP Gas Tank
Tank Tray Set
Island Bottom
Panel
Vent Openings must
be at least 1/8" wide.
5"
5"
5"
Tank Tray Set
1"
Partition Panel
(above the Gas Tank)
22-24"
21"
17-19"
8
5/8" UNF male
thread
Regulator Hose Connector
Figure 2
Figure 3
Advertisement
Table of Contents
