Table of Contents
Advertisement
CORRECT LP GAS TANK USE
LP Gas side burner models are designed for use with a
standard 20 lb. Liquid Propane Gas (LP Gas) tank, not
i nc l uded wi t h s i de bur ner .
to an LP Gas tank that exceeds this capacity. A tank of
approximately 12 inches in diameter by 18-1/2 inches high
is the maximum size LP Gas tank to use. You must use
an "OPD" gas tank which offers a listed Overfill Prevention
Device. This safety feature prevents the tank from being
overfilled which can cause a malfunction of the LP Gas Tank,
regulator, and/or side burner.
The LP Gas tank must be constructed and marked
in accordance with the Specifications for LP-Gas
Cylinders of the U.S. Department of Transportation
(D.O.T.) or the National Standard of Canada, CAN/
CSA-B339, Cylinders, Spheres and Tubes for Trans-
portation of Dangerous Goods; and Commission, as
applicable.
The LP Gas tank must have a shutoff valve, termi-
nating in an LP Gas supply tank valve outlet, that is
compatible with a Type 1 tank connection device. The
LP Gas tank must also have a safety relief device
that has a direct connection with the vapor space of
the tank.
The tank supply system must be arranged for vapor
withdrawal.
The LP Gas tank must have a collar to protect the
tank valve.
Never connect an unregulated LP gas tank to your
side burner. The gas regulator assembly supplied
with your gas side burner is adjusted to have an
outlet pressure of 11" water column (W.C.) for
connection to an LP gas tank. Only use the regulator
and hose assembly supplied with your side burner.
Replacement regulators and hose assemblies must
be those specified by Grand Hall.
Have your LP Gas dealer check the release valve
after every filling to ensure it remains free of defects.
Always keep LP Gas tank in upright position.
Do not subject the LP Gas tank to excessive heat.
Never store an LP Gas tank indoors. If you store your
side burner unit indoors, always disconnect the LP
Gas Tank first and store it safely outside.
LP Gas tanks must be stored outdoors in a well-
ventilated area and out of the reach of children.
Disconnected LP Gas tanks must not be stored in
a building, garage or any other enclosed area.
The regulator and hose assembly can be seen after
opening the island's door and must be inspected
before each use of the side burner. If your regulator
and hose are damaged in any way, they must be
replaced prior to using the side burner again.
Any attempt to convert your side burner from one fuel
type to another is extremely hazardous and will void
the warranty.
Never light your gas side burner with the lid closed
or before checking to ensure the burners are fully
seated over the gas valve orifices.
LP Gas Tank Installation
Never connect your side burner
Never allow children to operate your side burner. Do not
allow children or pets to play near your side burner. Always
supervise children and pets if they are in the vicinity of the
unit.
Use of alcohol, prescription or non-prescription drugs can
impair your ability to properly assemble and safely operate
your side burner.
Keep fire extinguisher readily accessible. In the event of a
oil/grease fire, do not attempt to extinguish with water. Use
type B extinguisher or smother with dirt, sand or baking soda.
In the event of rain, turn off the burners and gas supply. Wait
for the side burner to cool, and then place a cover on it.
Use your side burner on a level, stable surface in an area
clear of combustible materials.
Do not leave side burner unattended when in use.
Do not move the appliance when in use.
Allow the side burner to cool before moving or storing.
Do not use your side burner as a heater.
This side burner is not intended to be installed in or on
recreational vehicles and/or boats.
The side burner is not intended for commercial use.
Never use charcoal or lighter fluid in this gas side burner.
WARNING
!
A.
Do not store a spare LP-Gas tank under or near
this appliance.
B.
Never fill the tank beyond 80 percent full; and
C.
If the information in "(a)" and "(b)" is not followed
exactly, a fire causing death or serious injury may
occur.
WARNING
!
Refer to this table when designing the island unit for the
BTESB14ALP/NG Model. Side* and Rear* show the
minimum amount of distance the unit must be from
combustibles (ex. Vinyl or wood siding, fences and
overhangs) or sources of ignition (ex. Pilot lights on water
heaters and live electrical appliances). Height* shows the
minimum height the island unit must be starting from
the ground up.
Model
Height Width
BTESB14A
9-3/4" 12-3/4"
LP/NG
Side*
Height*
Height
10
Depth
Side* Rear* Height*
20"
36"
6" minimum clearance from
cutout (for lid)
Rear*
Non-combustible
Construction
Depth
Wide
!
!
36"
32"
Advertisement
Table of Contents
