Other; Factory Reset; Battery Check & Built-In Power Saving; Check Firmware - Profoto Air Remote TTL-O User Manual

Other

Factory reset

Reset the Air Remote TTL-O/P to factory settings:
• Switch off the Air Remote TTL-O/P.
• Press and hold down the Group Button C [4] and the ON button [1]
simultaneously.
Battery check & built-in power saving
The low battery symbol is displayed when the battery voltage reaches
17
a critical level.
To save battery, the display is partially dimmed after 20 seconds of
inactivity. Turns inactive after 2 minutes of inactivity. Press the ON
button [1] to switch on the display. The display also switches on when
any of the function buttons are used.

Check Firmware

Press and hold the MODE button [6] for 5 seconds when the remote
is turned on.

Upgrade Firmware

We recommend that you look for firmware upgrades before you start
using your new Air Remote TTL-O/P.
To access the latest free upgrades you create your personal account on
profoto.com/myprofoto. Once you have an account you can register your
products and be sure you get noticed when new upgrades are released.
Upgrade of firmware is made via the USB port [13] on the remote,
following the instructions provided in the upgrade application
downloaded from profoto.com/myprofoto. You can always contact
your local dealer or distributor for professional service.
To upgrade your Olympus/Panasonic camera to the latest version, visit
the Olympus/Panasonic webpage.
www.profoto.com