Table of Contents
Advertisement
The figure shows the Display [2] when:
• MAN mode, 1st-curtain sync, and channel 1 are selected.
• Group C is selected to be adjusted.
• Lights/Heads in Group B are turned off.
• The modeling light is turned on in both group A and C. If the light
output for group A or C is adjusted, the energy change will be shown
momentarily.
NOTE:
16
•
Press the ENERGY button to increase/decrease in 1/10 f-stop increments.
•
Press and hold down the ENERGY button to increase/decrease in 1 f-stop increments.
•
If a light output cannot be set by the flash because it is outside its energy range, the Air Remote TTL-O/P beeps
to signal that the command was not executed. The light output of all flashes in the selected group then remains
unchanged.
•
When all groups are selected the remote will also control lights in group D,E or F (selected on flash).
•
If the remote beeps when trying to exit MAN mode, it means that the MAN mode was requested by the camera.
Check the selected drive mode in your camera's menu.
Test sync
• Press the Test button [6] to manually transmit a sync signal.
www.profoto.com
Advertisement
Table of Contents
