Table of Contents
Advertisement
Operating instructions
Quick guide
For detailed instructions, refer to the subsequent sections.
Profoto Flash setups
1.
Set the flash to synchronization via Radio/Air (may differ by flash
models).
2. Select the same radio channel on all flashes.
3. Select the same group (A, B or C) for all lamp heads to be controlled
simultaneously.
Air Remote TTL-O/P
4. Slide the hot shoe connector on the Air Remote TTL-O/P into the
hot shoe of the camera. Turn the locking mechanism [14] to secure
the device.
5. Switch on the remote.
6. Select the same radio channel on the remote as on the flashes.
7.
Press the Mode button [6] to toggle between TTL (Automatic) and
MAN (Manual) mode.
8. Press the A, B or C button to select the corresponding group.
9. When a group is selected:
a) Press the HEAD button [9] to turn on/off the lamp heads/flashes.
b) Press the MODEL [10] button to turn on/off the modeling light.
c) Press the ENERGY buttons [3] to adjust the energy level for
the group in relation to the other groups (TTL mode) or the energy
level for the group (MAN mode). Since energy adjustments work
differently in TTL mode and Manual mode we recommend to
carefully read the detailed instructions for operation in both modes
on page 13-16 of this user guide.
10. Press the TEST button [5] to manually transmit a sync signal, in
order to test the settings.
www.profoto.com
11
Advertisement
Table of Contents
