Table of Contents
Advertisement
en Troubleshooting
Fault
Tableware is not dry.
Plastic tableware is not dry.
Cutlery is not dry.
Appliance interior still wet
after wash cycle.
Food remnants are left on
tableware in the top basket.
50
Cause
Extra Dry not activated to im-
prove drying performance.
Tableware removed too
early or drying process not
yet ended.
Rinse aid used has a limited
drying performance.
Appliance door does not
open automatically at the
end of the programme
Not a fault. As plastic does
not store heat so well, it also
does not dry as well.
Cutlery not arranged prop-
erly in the cutlery basket or
cutlery drawer.
Not a fault. The condensa-
tion drying principle causes
water droplets in the tub –
they are indeed desirable
here. The moisture in the air
condenses on the inside
walls, runs off and is
pumped out.
Tableware in the top basket
was placed too close to-
gether or top basket is over-
filled.
troubleshooting
Use a different combined detergent
2.
with a better drying performance.
Activate Extra Dry.
▶
Wait until the programme ends.
1.
Only remove tableware 30 minutes
2.
after the programme has ended.
Use a name-brand rinse aid.
▶
Eco products may have limited ef-
fectiveness.
Adjust the appliance door as de-
▶
scribed in the installation instruc-
tions.
The door gap must be at least
70 mm - 100 mm.
No remedial action possible.
▶
Droplets can form on the cutlery con-
tact points.
"Arrange cutlery individually where
1.
possible." → Page 34
Avoid points of contact.
2.
No action required.
Arrange tableware in the top basket
▶
with sufficient space in between.
Position large items of tableware at
an angle, e.g. pans and ovenproof
dishes.
Activate the Extra Clean Zone
‒
function in the top basket.
→ "Selecting Extra Clean
Zone", Page 25
Advertisement
Table of Contents
