Yamaha Nouvo AT115S Owner's Manual page 44

PERIODIC MAINTENANCE AND ADJUSTMENT
ZAUU0056
1. Engine oil strainer
2. Compression spring
3. O-ring
TIP
_
When only changing the engine oil, re-
move drain bolt A. When changing the
engine oil and cleaning the engine oil
7
strainer, remove drain bolt B also.
_
1 1 2 2
ZAUU0304
1. Engine oil drain bolt A
2. Engine oil drain bolt B
4. Clean the engine oil strainer with
solvent, and then check it for dam-
age and replace it if necessary.
5. Check the O-ring for damage and
replace it if necessary.
6. Install the engine oil strainer, com-
pression spring, O-ring and engine
oil drain bolt, and then tighten the
drain bolt to the specified torque.
TIP
_
Make sure that the O-ring is properly
seated.
_
7-10
Tightening torque:
Engine oil drain bolt A:
20 Nm (2.0 m·kgf, 14.5 ft·lbf)
Engine oil drain bolt B:
20 Nm (2.0 m·kgf, 14.5 ft·lbf)
7. Refill with the specified amount of
the recommended engine oil, and
then install and tighten the oil filler
cap.
Recommended engine oil:
See page 9-1.
Oil quantity:
0.80 L (0.85 US qt) (0.70 Imp.qt)
TIP
_
Be sure to wipe off spilled oil on any
parts after the engine and exhaust sys-
tem have cooled down.
_
NOTICE
_
● In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not
mix any chemical additives. Do
not use oils with a diesel speci-
ECA11620