Husqvarna FS5000 D Operator's Manual page 29

To do a check of the water supply to
the cutting blade
1. Loosen the front bolt on the blade guard and lift the
blade guard latch (A).
C
2. Lift the blade guard front (B) and lock the blade
guard in upright position with a wire and carabiner
(C).
3. Open the water valve.
1143 - 002 - 08.07.2019
A
4. Make sure that the jets of water go straight out from
the holes and onto each side of the cutting blade.
B
5. Make sure that there are no leakages in the water
pipes.
6. Replace the water pipes if they are damaged.
To drain the water separator for the fuel
filter
1. Put a container below the hose at the bottom of the
water separator for the fuel filter.
29