Testing Proposed Locations - DAVIS Wireless Repeater 7614 Instruction

AC-Powered Repeaters
Look for a sheltered location with access to an AC-power outlet. For exam-
ple, you could mount the repeater in a room or garage, or in one of Davis'
weatherproof shelters.
Solar-Powered Repeaters
Look for a location where you can position the solar panel to receive maxi-
mum exposure to the sun's rays:
The solar panel works best when the surface of the panel receives
full sunlight. Mount the panel away from fences, buildings, trees or
other obstructions that may cast shadows over the panel.
The panel should be mounted facing south in the Northern Hemi-
sphere and north in the Southern Hemisphere for maximum sun
exposure.

Testing Proposed Locations

Test your proposed transmitter, repeater and receiver locations to ensure suc-
cessful data transmission.
1. Make sure your transmitter and receiver are in position and are operating in test
mode.
To place the transmitter in test mode, flip dip switch #4 to "TEST" and then
power it up. To place the receiver in test mode, first apply power to the con-
sole and then flip dip switch #4 to the opposite side of wherever it was on
powerup. Refer to the Wireless Weather Station or SensorLink installation
manual for assistance if necessary.
In test mode, the transmitter's indicator LED will flash to indicate that the
sensor unit is transmitting and the receiver will beep whenever it receives
data from the transmitter (approximately every 2.5 seconds if the signal is
within range).
2. Temporarily place the repeater where you plan to mount it.
Single Transmitter, Single Repeater Installation Page 5