5. Loosen the screw heads on the terminal block.
You will eventually secure the heater cable wires underneath these screw
heads.
6. Secure the heater assembly to the Rain Collector.
For non-Vantage Pro Rain Collectors, secure the heater assembly to the Rain
Collector base using the #6-32 x 3/4" (19 mm) screws, a lock washer, and a
hex nut, as shown below.
Note:
Non-Vantage Pro Rain Collectors consist of Rain Collectors used with all Weather Wizard III,
Weather Monitor II, GroWeather, Health Enviromonitor and Energy Enviromonitor Weather
Stations.
Installing the Rain Collector Heater
Rain Collector Heater Terminal Block
Securing the heater in a Non-Vantage Pro Rain Collector
Terminal Block
Page 5