Advertisement
CHANGING THE LENS
● Open the light head by unscrewing the light head tube
counterclockwise and pull the tube carefully.
● Remove the lens manually by gently wiggling it.
● Insert the new lens, being careful so that its legs are
aligned correctly in the light base.
● Inspect the o-ring for damages and dirt. Replace o-rings or
clean them if necessary.
● Close the light head by pushing tube past the first o-ring.
Tighten the housing tube by turning clockwise. Be careful
so that the parts threading correctly to each other. Make
sure that the tube cover both o-rings.
USAGE
The drop-shaped knob controls the functionality of the light.
Loosening or tightening the screw can adjust knob friction.
SWITCH THE LIGHT ON
● Turn the knob clockwise.
● If the battery level falls below 10%, the amount of light will
automatically be reduced to optimize the battery
performance and allow the user to terminate the dive
safely.
SWITCH THE LIGHT OFF
● Turn the knob counterclockwise until it touches the
locking position, the light will go off with a delay of 2
seconds.
● Turn the knob counterclockwise past the locking position,
to ensure that the light does not come by accident, for
example during transport.
DIM THE LIGHT
● Turn the knob counterclockwise until it touches the
locking position, and back again within 2 seconds.
● Repeat the maneuver for further dimming.
● In this way, the light is dimmed gradually in four steps, and
back again to the highest brightness
Note that the light automatically dims down when the
battery level drops below 10%.
Advertisement
