Advertisement
CHARGE THE BATTERY
Charge with charge port:
● Open the lid of the charge port, located at the battery
canister, by pressing the lid and unscrew
counterclockwise.
● Connect the charger to the wall and plug in the DC
connector to the light.
● The charger will indicate charging by a red LED. A green led
will indicate completed charge.
● Disconnect the charger, inspect the o-ring for damages
and dirt. Replace o-rings or clean them if necessary, refit
the lid and make sure it is in the locked position.
Charge without charge port
● Open the battery canister by unscrewing
tube.
● Disconnect the battery connector by pulling
the connector apart. Never pull the cables!
● Connect the charger connector to the
battery connector. It is important that the
connectors are connected to each other in
the correct orientation.
● Plug the charger into a wall outlet. The
charger's indicator LED changes from red to
green when the battery is fully charged.
● When the battery is fully charged, disconnect
the charger connector and reconnect the
dive light connector. It is important that the
connectors are connected to each other in
the correct orientation.
● Inspect the o-ring for damages and dirt. Replace o-rings or
clean them if necessary.
● Make sure that the rubber bands around the battery is
tight and keeps cable and connector in place.
● Close the canister by pushing the canister tube past the
first o-ring. Tighten the tube by turning it clockwise. Be
careful so that the parts threading properly against each
other. Make sure that the tube cover the o-rings
completely.
Advertisement
