Advertisement
2. Try inserting the blankets into the MPS to make sure they fit. Adjust the folding
as necessary to make them fit.
3. Once you are sure the blankets will fit, remove the backing from the adhesive
strips on the insulation blankets and secure the blankets in the MPS.
4. You may install the heater in one of three locations in the MPS, as shown below.
Secure the heater to the MPS using the #6 screws.
Consult your MPS manual to determine the best mounting location for the
heater in your case.
R
OUTING THE
Follow the instructions below to route the heater cable from the heater to the
power unit.
Attaching Heater Cable to Heater
1. Route the cable into the shelter through one of the cable boots at the base of the
shelter.
2. If using the provided cable, twist the Red & White wires together to create a
single wire and twist the two Black wires together to create a single wire.
The bare wire may simply be cut off.
Routing the Heater Cable
I
NSTALLING
I
NSTALLING THE
H
C
EATER
ABLE
B
MPS
LANKET INTO
H
MPS
EATER IN THE
Page 7
Advertisement
