Advertisement
Use
- Hold both handle grips firmly. Step on the action decks properly according to the below
demonstration.
- Swing your low body to the right, and the swing to the left. Repeat to do these actions,
and then the scooter will move forward easily and continually.
- Braking: Brake is located in the right, when necessary, press it to slow down. Press
gradually in order to prevent skidding or loss of stability.
- Shoes are mandatory and we strongly advise you to wear long pants and long sleeve
shirts to avoid injury if you fall.
Care Instructions
A . Wheel bearings: Avoid going through water, oil or sand as this can damage wheel
bearings.
To look after the wheel bearings, systematically check that the wheels turn properly by
turning the scooter upside-down and using your hand to spin the wheels. If the wheels do
not spin they must then be removed to check their condition. First unscrew the wheel
axle, remove the axle and detach the wheel, then carefully push the two wheel bearings
out of their housing. If they are chipped or dented, new ones should be bought. If there is
no visible damage, they must then be oiled. To do this, remove all traces of grease, mud
or dust with a kitchen towel or cloth, and re-oil them with a grease spray or by leaving
them to soak overnight in oil [turn them several times in the oil first]. Remove and
reassemble the wheel bearings and axles, followed by the wheel, onto the scooter.
Proceed in the same manner for the other wheel.
B. Wheels: The wheels wear down with time and can be pierced if over used on rough
surfaces. In the interest of safety, they should be checked regularly and changed if
necessary.
3
Advertisement
