Davis Instruments Anemometer Installation Manual page 4

Assembling the Anemometer
Install the small end of the other drip ring on the wind cup end of the ane-
4.
mometer control head as shown below.
Note: The wind cup end of the control head has the smaller of the two stainless steel shafts.
5. Gently push up the drip ring until it reaches the groove on the control head.
Make sure the lower edge of the drip ring is aligned with the lower edge of
6.
the control head.
Attaching the Wind Cups
Before installing the anemometer, attach the wind cups. Wait until you have
installed the anemometer before you attach the wind vane.
1. Push the wind cups onto the smaller of the two stainless steel shafts at the
end of the arm.
2. Slide the wind cups as far up the shaft as possible.
Page 4
Installing the drip ring onto the anemometer control head
Push cups onto
stainless steel
shaft
Attaching wind cups to the anemometer
Tighten set screw
with allen wrench
Standard and Industrial Anemometer