Table of Contents
Advertisement
Huawei FusionServer Pro 2488 V5 Server
Technical White Paper
Indicator Description
Table 5-3 Indicators on the rear panel
Indicator
PSU indicator
UID indicator
Health status
indicator
Connection status
indicator for the
management network
port
Issue 11 (2020-09-03)
Description
● Off: No power is supplied.
● Blinking green at 1 Hz:
– The input is normal, the server is in standby
state, and the PSU is in MV6 mode (output
voltage is 6.7 V).
– The input is overvoltage or undervoltage.
– The PSU is in deep hibernation mode.
● Blinking green at 4 Hz: The firmware is being
upgraded online.
● Steady green: The power input and output are
normal.
● Steady orange: The input is normal, but no power
output is supplied.
NOTE
The possible causes of no power output are as follows:
● Power supply overtemperature protection
● Power output overcurrent or short-circuit
● Output overvoltage
● Short-circuit protection
● Device failure (excluding failure of all devices)
The UID indicator helps identify and locate a device.
● Off: The device is not being located.
● Blinking blue: The device has been located and is
differentiated from other devices that have also
been located.
● Steady blue: The device is being located.
NOTE
You can turn on or off the UID indicator by pressing the UID
button or remotely running a command on the iBMC CLI.
● Off: The device is powered off or is faulty.
● Blinking red at 1 Hz: A major alarm has been
generated on the system.
● Blinking red at 5 Hz: A critical alarm has been
generated on the system.
● Steady green: The device is operating properly.
● Off: The network port is not connected.
● Steady green: The network port is properly
connected.
Copyright © Huawei Technologies Co., Ltd.
5 Hardware Description
18
Advertisement
Table of Contents
