Miele WWI 860 Operating Instructions Manual page 71

Fault messages at the end of a programme
Problem

Align the washing
machine

Check filter + jet
The messages will appear at the end of the programme and when the washing
machine is switched on and need to be confirmed with the OK sensor.
Possible cause and remedy
The Pre-ironing Extra at the end of the programme
could not be carried out properly.
 Check whether the washing machine is aligned
correctly (see "Installation – Levelling the
machine").
 Check whether the maximum drain height of 1 m
has been exceeded.
If the fault message appears again, contact Miele. The
washing machine can still be used, but without the
Pre-ironing Extra.
The pumps are dirty.
 Clean the pumps as described in "Problem solving
guide – Opening the door in the event of a blocked
drain outlet and/or power cut".
 Restart the programme after cleaning.
The jet in the top of the door ring is blocked with fluff.
 Remove the fluff with your finger. Do not use any
sharp or pointed tools to do this.
 Restart the programme after cleaning.
If the fault message appears again, contact Miele. The
washing machine can still be used but with reduced
functionality.
Problem solving guide
71