BT Internet Radio User Manual page 7

3. Connect to the wireless network
With the name for the access point you want to connect to
displayed, press Select.
If your network is not configured to need an encryption code,
the display should show
.
Network OK
If the screen displays either
, then the network is using one of the encryption systems:
key
WEP or WPA and you will need to enter the correct code to
enable the radio to communicate with your network.
After about 3 seconds, the display goes into the code entry
mode. To enter the code, use the tuning dial to select each
character of the code in turn, pressing
character.
When you have entered the final character, use the tuning
dial to select and press Select.
END
The radio should now be able to connect to the network.
4. Connecting a headset (optional)
Connect the headset plug into the socket marked
side of the radio.
Your BT Internet Radio is ready for use.
Internet Radio – New Style – Edition 5 – 21.09.06 – 7690
Connecting to network
or
Enter WEP key Enter WPA
after each
Select
, then
The WEP or WPA code would have
been set up by the person who set up
and configured your wireless network.
WEP and WPA codes are sensitive to
upper and lower case characters so
you must enter them exactly.
Make sure the character you want is
shown in the centre of the display
before you press Select.
on the
Getting started 7