Assembly Instructions / Liner Layout - Quik Swim Pool QS-1648 Owner's Manual

Pool assembly / Liner layout
8
Step 5:
Begin inserting the upper frame rails ( a ) into the sleeves located at the top of the liner. Center the
beam in the sleeve and attach a t connector ( c ) to the end of the frame rail in the open space between
each sleeve. Insert the smaller end of the top rail into the larger end of the t-connector lining up the
plastic pin making sure you hear a "click." Repeat this step until all of the upper frame rails and t connec-
tors have been connected.
Step 6:
Once all of the upper frame rails have been connected it is time to attach the vertical legs. Begin by slid-
ing one vertical leg ( b ) through the retaining belt and attaching it to the t connector ( c ) pushing in on
the pins and aligning the holes until you hear a "click." Double check that the vertical leg has been in-
serted in the restraining belt and proceed to the next leg repeating these steps until all of the vertical
legs are in place. Next go around the pool attaching the plastic feet ( d ) to each of the vertical legs ( b ).