Antenna Connections - Hitachi UltraVision C55LS8 Owner's Manual

Hide thumbs Also See for UltraVision C55LS8:
Table of Contents

Advertisement

Available languages

Available languages

Antenna connections

If you are using an indoor or outdoor antenna, follow the instructions below that correspond to your
antenna system. If you are using a Cable TV service, see Cable TV connections.
Combination VHF/UHF Antenna (Single 75 ohm cable)
Antenna
Jack
75 ohm
Coaxial
Cable
Cable TV connections
This TV has an extended tuning range and can tune most cable channels without using a Cable TV
Converter box. Some cable companies offer "premium pay channels" where the signal is scrambled.
Descrambling these signals for normal viewing requires the use of a descrambler device which is
generally provided by the Cable TV company.
For subscribers to basic Cable TV service
Antenna
75 ohm
Coaxial Cable
For subscribers to scrambled Cable TV service
If you subscribe to a Cable TV service which requires the use of a Converter/Descrambler box, connect the
incoming 75 ohm Coaxial Cable to the Converter/Descrambler box. Using another 75 ohm Coaxial Cable, connect
the output jack of the Converter/Descrambler box to the Antenna Jack on the TV. Follow the connections shown
below. Set the TV to the output channel of the Converter/Descrambler box (usually channel 3 or 4) and use the
Converter/Descrambler box to select channels.
Incoming 75 ohm Cable TV Cable
For subscribers to unscrambled Cable TV service with scrambled premium channels
If you subscribe to a Cable TV service in which basic channels are unscrambled and premium channels require
the use of a Converter/Descrambler box, you may wish to use a signal Splitter and an A/B Switch box (available
from the Cable TV company or an electronics supply store). Follow the connections shown below. With the switch
in the "B" position, you can directly tune any non-scrambled channels on your TV. With the switch in the "A" position,
tune your TV to the output of the Converter/Descrambler box (usually channel 3 or 4) and use the Converter/
Descrambler box to tune scrambled channels.
Incoming
75 ohm
Cable TV
Cable
Connect the 75 ohm cable from the combination VHF/UHF antenna to the
Antenna Jack.
For basic Cable TV service not requiring a Converter/Descrambler box,
connect the 75 ohm Coaxial Cable directly to the Antenna Jack on the back
of the TV.
Jack
Converter/
Descrambler
Converter/
Descrambler
Splitter
75 ohm Cable to TV
75 ohm Cable to TV
A
A/B Switch
B
Antenna
Antenna
Jack
Jack
75 ohm
Coaxial Cable
Antenna
Antenna
Jack
Jack
75 ohm
Coaxial Cable
EN 13

Advertisement

Table of Contents
loading

Table of Contents