Alpine INE-W611D Installation Manual page 8

〇①〇 Radio Antenna Receptacle
〇②〇 Speed Sensor Lead (Green/White)
Improper connection of the speed pulse line may cause
important safety features of the vehicle to fail (such as the
brakes or air bags). Such failures may result in an accident
and loss of life. We strongly recommend that the installation
be performed by a trained, authorized Alpine dealer.
〇③〇 Rear Camera Input Connector (RCA)
〇④〇 Front or Side Camera Input Connector (RCA)
〇⑤〇 AUX Input Connector
Input lead for AUX video/audio signal.
〇⑥〇 Remote Turn-On Lead (Blue/White)
Connect this lead to the remote turn-on lead of your amplifier
or signal processor.
〇⑦〇 Reverse Lead (Orange/White)
Connect to the plus side of the car's reverse lights. These
lights illuminate when the transmission is shifted into reverse
(R).
With this lead properly wired, the video picture automatically
switches to the rear camera whenever the car is put into
reverse (R).
〇⑧〇 Power Antenna Lead (Blue)
Connect this lead to the +B terminal of your power antenna,
if applicable.
• This lead should be used only for controlling the vehicle's
power antenna. Do not use this lead to turn on an amplifier
or a signal processor, etc.
〇⑨〇 Parking Brake Lead (Yellow/Blue)
Connect this lead to the power supply side of parking brake
switch to transmit the parking brake status signals to the
unit.
〇⑩〇 Switched Power Lead (Ignition) (Red)
Connect this lead to an open terminal on the vehicle's fuse
box or another unused power source that provides (+)
12V only when the ignition is turned on or in the accessory
position.
〇⑪〇 Fuse Holder (15A)
〇⑫〇 Battery Lead (Yellow)
Connect this lead to the positive (+) post of the vehicle's
battery.
6
-EN
〇⑬〇 Ground Lead (Black)
Connect this lead to a good chassis ground on the vehicle.
Make sure the connection is made to bare metal and is
securely fastened using the sheet metal screw provided.
〇⑭〇 Left Rear (+) Speaker Output Lead (Green)
〇⑮〇 Left Rear (–) Speaker Output Lead (Green/
Black)
〇⑯〇 Left Front (+) Speaker Output Lead (White)
〇⑰〇 Left Front (–) Speaker Output Lead (White/
Black)
〇⑱〇 Right Front (–) Speaker Output Lead (Gray/
Black)
〇⑲〇 Right Front (+) Speaker Output Lead (Gray)
Right Rear (–) Speaker Output Lead (Violet/
20
Black)
Right Rear (+) Speaker Output Lead (Violet)
21
Remote Control Output Lead (Gray) (For Rear
22
Monitor)
Connect this lead to the remote control input lead. This lead
outputs the controlling signals from the remote control.
Remote Control Input Lead (Gray) (For Rear
23
Monitor)
Connect the external Alpine product to the remote control
output lead.
Remote Control Output Lead (Gray) (For Aux)
24
Connect this lead to the remote control input lead. This lead
outputs the controlling signals from the remote control.
Steering Remote Control Interface Connector
25
To steering remote control interface box.
For details about connections, consult your nearest Alpine
dealer.
MIC Input Connector
26
To microphone (Included)
• When using the included microphone, set Microphone
Select to "Add-on" For details, refer to "Setting the
Microphone Select" in the OWNER'S MANUAL.