Table of Contents
Advertisement
Designed with flexibility in mind, the 30" double side burner/griddle can be either built-in
or mounted on a freestanding cart. If the unit is to be placed onto a freestanding cart, an
approved DCS cart is required and can be purchased separately from your local DCS dealer.
CAD1-30 freestanding cart part number: 71131
Preparing the double side burner/griddle
support bracket
1
(remove on
both sides)
cart bracket
2
(secure on
both sides)
13
FREESTANDING CART INSTALLATION (OPTIONAL)
IMPORTANT!
For further guidance, refer to the installation
z z
guide provided with your freestanding cart.
Wear gloves when handling the cart, some
z z
edges may be sharp.
Two or more people are required to move
z z
and assemble the cart.
Push or pull the cart at the corners, do not
z z
move by the drawers or handles.
To prevent tipping, do not push down on top
z z
of the drawers.
For optimal use, this product should be
z z
located on a level surface with minimum flat
area of 30x48" (762 x 1219mm). Any bumps,
cracks or protrusions should be less than 1/4".
Do not overload the drawers. The maximum
z z
rating of each drawer is 35lbs.
Remove the support brackets from
the sides of the unit and replace with
the supplied cart mount brackets.
Secure cart mounting brackets
using four of the supplied 10-24 x
1/2" screws on each side.
Securing side burner/griddle to cart
1
2
3
Remove the drip pan and any other
removable components from the
double side burner/griddle.
cart bracket
fixed to side of
burner/griddle
Place the side burner/griddle on the
cart by locating the rear side tabs of
the unit with the slots on the cart.
Lower the side burner/griddle and
locate the remaining tabs.
The side burner/griddle should sit
flush on the cart.
Secure the side burner/griddle to
the cart with two Phillips-head
screws at the rear and three at the
front.
Replace any components removed
in step 1 before referring to page 9
for gas connection advice.
Advertisement
Table of Contents
