Table of Contents
Advertisement
Available languages
Available languages
3.3. EXTINGUISHING THE FLAME / END OF OPERATION
•
When finishing the cutting process, close always the cutting oxygen valve first, then the
fuelgas valve and finally the preheating oxygen valve.
•
After the flame is extinguished, close the closing valves at the oxygen and fuel gas cyl-
inder.
•
Open, little by little, the valves of both gases and ventilate gases from the hoses.
•
Set the regulator valves on the zero output pressure level by releasing of control springs.
4.
MAINTENANCE, SERVICING, REPAIRS
4.4. MAINTENANCE
Clean the openings in tips only with appropriate cleaning needles; any damage of the tip
affects negatively the cutting torch function.
Check the whole system for tightness periodically.
Do not damage sealing surfaces in the torch head.
4.5. LIFETIME
Lifetime of products in use with high pressure gases is 10 years
4.6. REPAIRS
All repairs have to be carried out by manufacturer or authorized service centre only.
More information on www.gcegroup.com
5.
WARRANTY
The Standard Warranty period is two years from date of receipt by the GCE Customer (or
if this is not known 2 years from time of the product manufacture shown on the product).
The standard warranty is only valid for products handled according to Instruction for use
(IFU) and general industry good practice and standards.
5/16
EN
Advertisement
Table of Contents
